ToughSonic 30 Ultrasonic Sensor from Senix

Maximum Range 30 feet (9.1 Meters)

The ToughSonic 30 ultrasonic sensor has a maximum range of 30 feet (9.1 meters). Like all ToughSonic sensors, it’s built for durability and ease of use in tough industrial environments. It’s fully immersible, corrosion resistant, shock resistant and all around tough. It is also fully configurable with SenixVIEW software.

ultrasonic sensors housed in stainless steelThe 1.5 inch (38.1 mm) housing has 1.5 inch NPT threading on each end and a smooth middle section for a variety of mounting options. This sensor has a 9-wire cable that allows up to six simultaneous serial, analog and/or switch outputs. These workhorse sensors are used around the world in remote monitoring and demanding factory environments.

For longer range applications or for chemically resistant sensors, please see our full line of ToughSonic and ToughSonic CHEM sensors.

ToughSonic 30 Options

Serial Interface

The ToughSonic 30 is available with one of the following Modbus serial data interfaces.

RS-232
Modbus RS-232 serial data interface

RS-485
Modbus RS-485 serial data interface

Sensor Customization

Custom SenixVIEW configurations can be pre-loaded.
Alternative cable type, length and connections are available.

Our ToughSonic ultrasonic sensors offer extraordinary features and flexibility. If you need sensor capabilities that are not listed here, please contact us.

Tough:

ToughSonic ultrasonic sensors are built Tough with:

1.18 inch (30 millimeter) type 316 stainless steel housing.
Sealed epoxy potting for wet and dirty applications.
Ruggedized piezoelectric ultrasonic transducer, potted in place.
Hardened ToughSonic internal electronics.
UV resistant, potted-in cable.
Short and overload protected input / output.

:Smart

ToughSonic ultrasonic sensors are built Smart with:

SenixVIEW configuration and analysis software controlling more than 60 performance parameters, and dozens of viewing, analysis and maintenance options.
Push-button “Teach” feature.
Multi-sensor network capable.
Up to six simultaneous, industry standard outputs

Specifications
Maximum Range	3 feet (91 centimeters)
Optimum Range	10 inches - 20 feet (25.4 cm- 6.1m)
Temperature	-40º to 158º F (-40º to 70º C)
Humidity	0 to 100% operating
Protection	NEMA-4X, NEMA-6P, IP68
Transducer	Ruggedized piezoelectric
Compensation	Temperature compensated
Resolution	Digital: 0.0068 in. (0.172 mm); Analog:4099 steps (0-10 VDC), 3279 steps (4-20 mA)
Repeatability	Nominal 0.2% of range @ constant temp. Affected by target, distance, environment
Update Rate	10 Hz (100 ms), SenixVIEW adjustable; affected by SenixVIEW filter selections

Specifications are subject to change without notice.

Outputs
Voltage Output	0-10, 0-5 VDC or SenixVIEW customized; 10mA max
Current Loop #1	Current sourcing 4-20 mA or PC customized, max. loop 450Ω
Current Loop #2	Current sinking 4-20 mA or PC customized, max. loop 450Ω
Sinking Switch	150 mA max. @ 40 VDC max., teachable set point & polarity, fault indication
Sourcing Switch	150 mA max. @ input voltage, teachable set point & polarity, fault indication
RS-232, RS-485	Modbus protocol, 9600-115200 baud (selectable), 8 data bits, 1 stop, no parity
SYNC feature	Permits up to 32 sensors to operate in close proximity without interference

Mechanical

Mounting	1.5 inch NPT thread, top or bottom
Attached Cable	6.5 feet (2 meters)
Total Weight	22.6 oz. (0.64 kg)

Specifications are subject to change without notice.

Downloads

Manual

Data Sheet

ToughSonic 30 Ultrasonic Sensor from Senix

About Us

Our Products

Website Content

Get in Touch